99热这里只有精品九九_无码专区中文字幕视频在线_亚洲欧美日韩综合久久久久_中文字幕aⅴ天堂在线

Welcome to the website of Baoji Zhongheng Instrument Co., Ltd. Tel:+86-917-3512881
Differential pressure transmitter Single crystal silicon pressure transmitter Electromagnetic flowmeter Capacitive pressure transmitter High precision pressure transmitter Intelligent pressure switch Diffused silicon pressure transmitter Flow switch Intelligent pressure transfer controller Thermometer

BXY63Z43 Intelligent Pressure

Product code

 

Overview

Display the current pressure value with 4 digit
Product quotationProduct consulting在線訂購

Product introduction

1、 Overview
Electronic pressure switch is an intelligent digital pressure measurement and control product that integrates pressure measurement, display, output, and control. This product is a fully electronic structure, with a front end equipped with a pressure sensor with isolation film filling oil pressure resistance. The output signal is amplified and processed by a high-precision, low-temperature drift amplifier, and sent to a high-precision A/D converter, which is converted into a digital signal that can be processed by a microprocessor. The processed signal controls two switches to measure and control the pressure of the control system. This pressure switch is flexible to use, easy to operate, easy to debug, and safe and reliable. Widely used in industries such as hydropower, tap water, petroleum, chemical, mechanical, hydraulic, etc., to measure, display, and control the pressure of fluid media
2、 Characteristics
Display the current pressure value with 4 digits.
Pressure preset switch point and hysteresis switching output
The switching value can be arbitrarily set between zero and full scale
◆ The shell is equipped with a node action LED for easy observation
Key adjustment and on-site setting of various parameters, easy to operate
◆ 2 switch outputs, with a load capacity of 1.2A
There are two options for switches: PNP and NPN,
Analog output (4-20mA) optional
◆ The shell can rotate 330 °
3、 Technical parameters:




4、 Installation
4.1 Mechanical connection:
This product can be directly installed on the hydraulic pipeline through a pressure pipe joint (DIN3582 external thread M20 * 1.5) (other sizes of joints can be specified when ordering). In critical applications such as severe vibration or impact, pressure pipe joints can be mechanically decoupled through micro hoses.
4.2 Electrical connections:
To prevent the impact of electromagnetic interference, the following precautions should be taken:
Using shielded wires, if installed with micro hoses, the casing must be grounded separately
Try to avoid directly approaching the wiring of user devices or electrical and electronic devices that cause interference as much as possible



5、 Overall dimensions

6. Setting functions
6.1 Switching output
This switch has 1-2 switching outputs. Each switch output can be set with one pressure switch point and one opening delay value.
The corresponding output will switch when the suction value of the switch point reaches and return when the pressure drops below the release value.
6.2 Setting Switch Points
AL1H This value is the pull-in value of switch 1 (when the pressure reaches this point, the indicator light is on)
AL1L This value is the release value of switch 1 (when the pressure reaches this point, it is disconnected and the indicator light is off)
AL1D This value is the delay of switch 1 action (the number of seconds that must be waited before switching)
AL2H This value is the pull-in value of switch 2 (when the pressure reaches this point, the indicator light is on)
AL2L This value is the release value of switch 2 (when the pressure reaches this point, it is disconnected and the indicator light is off)
AL2D This value is the delay of switch 2 action (the number of seconds that must be waited before switching)









?